ZHANG: 139 526 298,742,880,390,815 Jingjiang Connaught bearing heater factory direct bearing heater monopoly, custom large bearing heater bearing heater selection SL30H Specifications: Model Rated Capacity (KVA) For the workpiece dimensions (mm) The maximum outside diameter of the inner diameter of the maximum width SL30H-1 2 20-110 300 100 SL30H-2 7.6 80-180 360 150 SL30H-3 11 100-250 400 170 SL30H-3A 11 80-400 600 200 SL30H-4 16 130-400 580 180 SL30H-5 35 130-500 700 200 SL30H-6 45 150-700 900 250 bearing induction heater advantages are: the product during the heating process can be automatic demagnetization, residual magnetic bearings after heating for: 2A / CM, in line with ZQ33 -85 standard, the host is using the next three bags of eighteen months. Workpiece is heated evenly, absolutely clean, help to improve the quality of assembly. Fuel-saving and energy-saving plant covers an area more than four times the work efficiency, an operator can easily solve assembly problems; built-in thermal protection system, safe and reliable no fire hazards; no fumes polluting the air, help improve the environment and work health personnel installation and commissioning a heater installed in the pipeline right position. Host right direction should be horizontal, vertical front tilted backwards to allow no more than 3 degrees. 2. After installation is complete, before using electrical schematics must be reviewed, the wiring is correct. 3, correct, close the switch, the power, the device should indicate a red light. 4, the bearing is placed is heated to a yoke, the yoke in contact with the end face of the anastomosis. So far, commissioning end can be put to use. Procedure 1, press the START button, the host is powered relay starts counting the time, in seconds, the bearing is heated. 2. Press the stop button before, saw time count, then remove the artifacts, to measure the inner diameter of the end plane of the temperature meets the requirements in order to suit (after bearing the same specifications just simply follow the standard set time to). 3, the continuous heating of the same size of the workpiece, the function selector switch to the automatic position, set the heating time, when the workpiece is heated to the set time automatically shut off the power. 4, after the work is completed, the power switch to the stop position, turn off the power.