ZHANG: 139 526 298,742,880,390,815 Jingjiang Connaught bearing heater factory direct bearing installation tool by the end of the promotion, bearing heater monopoly, custom large bearing heater, bearing heater lowest end of the year, bearing heater bearing heating supplier details the HA bearing heater uses: HA series bearing heater, mainly used for bearings, gears, bushings, bushings, diameter ring, pulleys, shrink metal rings, connectors and other types of heating by heating them to expand, reaching over surplus assembly required. Structure: HA series bearing heater control box by a combination of host and one installed in the primary car, mobile structure, flexible and easy to use on-site construction, removable yoke is directly used to wear a sleeve bearing or other heating workpiece. Procedure 1, the yoke is placed on the end face of the host. 2. Put the plug in the power socket on the control switch. 3. Check the grounding line is good, the power with pencil test. 4, press the start button, the host power. 5, check the yoke on the ground should be no voltage. 6, press the stop button on the host power, stop heating. 7, depending on the specifications of the bearing or other workpiece, select a different yoke sleeve, this yoke at the top surface of the host, should be consistent smooth. 8, when heated, the sensor should be inserted into the "sensor socket" and the sensor close to the workpiece is heated. 9, when the bearing is heated to the desired temperature, it will automatically turn off the power or press the stop switch. 10, after the cessation of heating, yoke left or right to move, remove the bearing will host the top and then back yoke. 11, if reused, uninterrupted heating bearings, just to the processing of the bearing sleeve into the yoke again, click on the Start button. Note 1, the power supply lines must be well grounded. 2, the host is not placed in front of the yoke, prohibited press the start button switch, otherwise it will damage the instrument or blown fuses. 3, ball bearing heater temperature not exceeding 150 ℃. Otherwise it will cause bearing annealing. 4, in order to improve the heating efficiency, while bearing bore size to select the appropriate according to yoke, should try to choose the larger cross-sectional area of ??the yoke. 5. Do not skewed host must be laid flat, the end face of the yoke shall be consistent with the host. 6, must be powered down when the host, before taking the yoke of the heating element. 7, bearing temperature, pore volume rose see the table below.