Jingjiang bearing heater factory direct bearing installation tool by the end of the promotion, custom large bearing heater, bearing heater lowest end ZHANG: 139,526,298,740,523 8,495,505,828,803,908 15 Connaught YZHA-3 bearing heater details Introduction Connaught YZHA-3 bearing heater, mainly used for bearings, gears, bushings, bushings, diameter ring, pulleys, contractile ring, connectors and other types of metal is heated, it expands by heating, reached full assembly required. Pros: 1. Save money-saving 90%, saving 100%, saving the plant covers an area of ??70% 2. timesaving efficiency increased by four times, the operator reduced by 60%. 3. Reliable uniform heating, absolutely clean, help to improve the quality of assembly. 4. Security no fire hazards. 5. Environmental non-oil gasoline pollution of air, is conducive to improving the health of the environment and the staff. Jingjiang Connaught Instrument Co., Ltd. has been engaged in the production of heaters 10 years, through continuous accumulation of technology innovation and experience in the development and production of a series of instruments promise for all types of workpieces induction heaters, such as ZN series, ZND series, ZNE series , ZNY series. Connaught YZHA series bearing heater Instructions: 1, the yoke placed on the end face of the host. 2. Put the plug in the power socket on the control switch. 3. Check the grounding line is good, the power with pencil test. 4, press the start button, the host power. 5, check the yoke on the ground should be no voltage. 6, press the stop button on the host power, stop heating. 7, depending on the specifications of the bearing or other workpiece, select a different yoke sleeve, this yoke at the top surface of the host, should be consistent smooth. 8, when heated, the sensor should be inserted into the "sensor socket" and the sensor close to the workpiece is heated. 9, when the bearing is heated to the desired temperature, it will automatically turn off the power or press the stop switch. 10, after the cessation of heating, yoke left or right to move, remove the bearing will host the top and then back yoke. 11, if reused, uninterrupted heating bearings, just to the processing of the bearing sleeve into the yoke again, click on the Start button. Note: 1, the power supply lines must be well grounded. 2, the host is not placed in front of the yoke, prohibited press the start button switch, otherwise it will damage the instrument or blown fuses. 3, ball bearing heater temperature not exceeding 150 ℃. Otherwise it will cause bearing annealing. 4, in order to improve the heating efficiency, while bearing bore size to select the appropriate according to yoke, should try to choose the larger cross-sectional area of ??the yoke. 5. Do not skewed host must be laid flat, the end face of the yoke shall be consistent with the host. 6, must be powered down when the host, before taking the yoke of the heating element.